A clean, well appointed 48” Separator Package. Built by Presson in 2000, this unit was designed to pump condensate right off the bottom the vessel via dual Wheatley T255M triplex pumps w/ 1.25” plungers. Vessel is a 2 Phase design shut down & blocked in in 2013; opened, cleaned and installed a nitrogen blanket in July 2015. In addition, everything is fully wired to junction boxes c/w lights, fire loop, beacons, ESD, 120V start Catadynes, exhaust fans etc. Located by Rocky Mountain House.

Skid & building are 11’ W x 36’ L

Shipping dimensions are with prover lines removed as well as door & outside light hoods 13’ 5” W x 38’ 6” L x 17’ H including ridge vent. (16’6” + 6”)

Drawings do not exist.

View Virtual Tour

Ready to go! Sour rated but only ever operated in sweet service! This 60” x 300# separator built by ARGO Sales is their standard design/stock unit.  It’s a simple and effective unit: solid design, three province registration, 3 Phase Dressed 3, metering, fuel gas scrubber and a comprehensive end device package fully wired to JB’s.  Located close to Calgary for personal inspections and can be moved out anytime.

Building is 12’ W x 23’ L / Skid is 12’ W x 27’ L

Ships 13’ W (with exhaust fan hood removed) x 28’ 6” L x  14’ 3” H

Drawings available upon request.

View Virtual Tour

CAT G3516 S#4EK03117, 1040kW, 277/480V 3ph, 60Hz, 1800rpm, natural gas fueled CAT 3516 engine, EMCP2+ digital control panel, 1600A breaker, heavy duty air cleaners.

ACCESSORIES: battery charging alternator, electric start, AC battery charger, jacket water heater, sound attenuated enclosure

SERVICE WORK: Generator set will be serviced and load bank tested to 100% capacity prior to pick-up.

DIMENSIONS
L - 455"
W - 139"
H - 157" Easily transported to site for power generation.

DRIVER:
Frame: 710B
Volts: 4000
Amps: 382
Hz: 60
Phase: 3

COMPRESSOR:
ONE (1) New Surplus Ariel JGC-4 frame, balanced opposed reciprocating compressor, four (4)
throw, 6
1/2” stroke, rated at 4140 Hp at 1000 RPM. Maximum total rod load 114,000 lb ( 60,000
compression - 57,000 tension). Frame is equipped with a forged steel crankshaft with integral
counterweights.
Pressurized Lube system utilizes a frame-driven lube oil pump which provides oil circulation
through a full flow oil filter to all moving parts to the frame. A divider block distribution system
supplies metered oil to cylinder bores and rod packing. Stainless Steel tubing is used
throughout the cylinder lubrication system.

COOLER IS NOT INCLUDED

Both turbine units are in excellent condition with very low hours for their age. Each unit has had the generator end refurbished (documentation included). General refurbishment activities on the remaining items has been completed.

Units have 15,166 & 20,222 hours of use. 292 & 472 starts.

5.2MW at sea level, 59°F, no inlet or exhaust losses, 11,882 BTU/kwh on Natural Gas. Inlet and exhaust ducting, Self Cleaning inlet air filter, Electric motor starting, Outdoor enclosures, control cab with switchgear, MCC, etc.

Commissioned in 11/6/01, and maintained by Solar. Taken out of service, stored inside building 2006-2009 disassembled and moved in 2009 to present site and inspected by Solar. Generator Ends rebuilt. May 30, 2019 Borescope reports available.

MORE PICTURES TO COME

Description:

1. GE 7EA GTG Packaged Power Plant.

The package comprises the following major components along with all GE scope of supply and auxiliaries:

• Frame 7EA Gas Turbine model PG7001EA (7E.03)

• Dry Low NOx (for DLN 1.0 Combustion System)

• Natural gas single fuel supply

• Output/Heat Rate 87MW and 10,480 btu/kwh at 1916 ft

• Includes GE PIP package (minus Stg 3 Aero), 2055F firing temp.

• Inlet/Exhaust: Pressure drop: 3.5/5.5 inches of H2O

• Design site elevation: approx. 1916ft above sea level.

• Hours: factory test fire only, ie New.

• Control System; MKV1e Speedtronic TMR.

• Generator; GE/Andritz

• Frame: BDAX (Brushless)

• Excitation: GE EX2100

• Terminal Voltage: 13.8Kv (2 pole, 3-phase, Wye conn.)

• Frequency/Power Factor: 60 Hz/0.85 pf

• Rated Output: 86.5 mw/101.8 MVA

• 52G synchronizing breaker compartment included @ 13.8KV incl. all protection relays etc.

• Cooling: Air-cooled.

• Design for Canadian Market. Stored in accordance with GE's storage/preservation requirements.

Additional Options:Combustor Components to be selected and agreed upon between buyer and seller. Contact seller for more information

Burner systems are not included

PRODUCED WATER, Portable