86.5 MW GE (General Electric) 7E.03 Natural Gas Generator Package
Listing ID:
IH-10440
Published
Notes:
Description:
The package comprises the following major components along with all GE scope of supply and auxiliaries:
- Frame 7EA Gas Turbine model PG7001EA (7E.03)
- Dry Low NOx (for DLN 1.0 Combustion System*)
- Natural gas single fuel supply
- Design Site Output/Heat Rate 84.6MW at 1916 ft and 32°F; 91MW at 0 ft and 32°F
- Includes GE PIP package (minus Stg 3 Aero), 2055°F firing temp
- Inlet/Exhaust: Pressure drop: 3.5/5.5 inches of H2O
- Hours: factory test fire only, i.e. New
- Control System: MKVIe Speedtronic TMR
- Generator: GE/Andritz
- Frame: BDAX (Brushless)
- Excitation: GE EX2100
- Frequency/Power Factor: 60 Hz/0.85 pf
- Rated Output: 101.8 MVA
- Cooling: Air-cooled
- Designed for the Canadian Market
- Stored in accordance with GE's storage/preservation requirements
- Unit has not been rotated - Not required on 3 bearing units
- Borescope on GTG and quarterly electrical insulation resistance check on the generator
Other Auxiliary Equipment Available Upon Request
(not included in asking price - please call us to inquire):
- Air Cooled Glycol Heat Exchangers c/w VFD’s, Filters, Glycol Pumps, GSU Transformer,
- Glycol Expansion Vessel, 52G synchronizing breaker compartment included @ 13.8KV incl. all protection relays etc. - Terminal Voltage: 13.8Kv (2 pole, 3-phase, Wye conn.)
- Heat Recovery Steam Generator (HRSG – Not Complete)
Electrical/substation components additional details (could potentially be sold additional to the GTG pkg [GE scope of supply]):
- 1 x Siemens, 5,600A self-cooled, 13.8kV, 95kV BIL, fixed mounted generator breaker in enclosure
- 1 x 75/100/125 MVA, 13.8kV – 260kV, oil-filled generator step-up transformer (see attached “GSU datasheet”)
- Various low voltage motor control centres for all auxiliary loads
- Generator Protection Panel including two GE Multilin G60 generator protection relays
*Combustion system (for GTG) not included or installed – Combustor Components from refurbished parts are available upon request at additional cost.
Below is the list of missing combustion components:
- Primary Fuel Nozzles
- Secondary Fuel Nozzles
- Flow Sleeves
- Liners
- Cross Fire Tubes
- Transition Pieces and TP Seals
- All gaskets, nuts, bolts, screws, pins to install the above
Share item via